Table of Contents
Advertisement
CPU and chassis fan connectors (4-pin CPU_FAN, 4-pin CHA_FAN)
Connect the fan cables to the fan connectors on the motherboard, ensuring that
the black wire of each cable matches the ground pin of the connector.
ATX power connectors (24-pin EATXPWR, 8-pin ATX12V)
Correctly orient the ATX power supply plugs into these connectors and push down
firmly until the connectors completely fit.
Intel
®
Install Intel
designed for 6th Generation Intel
processors.
DDR4 DIMM slots
Install 2 GB, 4 GB, 8 GB, and 16 GB unbuffered non-ECC DDR4 DIMMs into these
DIMM sockets.
Intel
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA
6.0 Gb/s signal cables.
1-2
Do not forget to connect the fan cables to the fan connectors. Insufficient air
flow inside the system may damage the motherboard components. These are
not jumpers! Do not place jumper caps on the fan connectors! The CPU_FAN
connector supports a CPU fan of maximum 1A (12 W) fan power.
•
For a fully configured system, we recommend that you use a power supply
unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version)
and provides a minimum power of 350 W.
•
If you are uncertain about the minimum power supply requirement for your
system, refer to the Recommended Power Supply Wattage Calculator
at http://support.asus.com/PowerSupplyCalculator/PSCalculator.
aspx?SLanguage=en-us for details.
LGA1151 CPU socket
LGA1151 CPU into this surface mount LGA1151 socket, which is
®
For more details, refer to Central Processing Unit (CPU).
For more details, refer to System memory.
B150 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~4)
When using hot-plug and NCQ, set the SATA Mode Selection item in the BIOS
to [AHCI].
Core™ i7 / i5 / i3, Pentium
®
Chapter 1: Product introduction
, and Celeron
®
®
Advertisement
Table of Contents
