Braun 750 cc-3 Manual page 13

«clean» shaver is clean
« » short economical cleaning required
« » normal level of cleaning required
« » high intensive cleaning required
If the station selects one of the required cleaning
programs, it will not start unless you press the
«start cleaning» button
results, we recommend cleaning after each
shave.
Each cleaning program consists of several
cycles, where cleaning fl uid is fl ushed through
the shaver head. Depending on the program
selected, the cleaning time takes 3 to 15 minutes
and drying takes about 4 hours. During this time
the respective indicator blinks.
The cleaning programs should not be inter-
rupted. Please note that whilst the shaver is
drying, the shaving head may be wet.
When the program is fi nished, the blue «clean»
indicator will light up. Your shaver is now clean
and ready for use.
Stand-by mode
10 minutes after completing the charging or
cleaning session, the Clean&Renew station
switches to the stand-by mode: The indicators
of the Clean&Renew station turn off.
Shaver display
The green indicator fl ashes when the shaver is
being charged or when in use.
When the battery is fully charged, the charge
segment «high» will light up continuously
provided that the shaver is switched on or
connected to an electrical outlet.
Low charge indicator:
The red «low» indicator fl ashes when the battery
capacity has dropped below 20%, provided the
shaver is switched on. The remaining capacity
will then be suffi cient for 2 to 3 shaves.
Charging information
• A full charge provides up to 50 minutes
of cordless shaving time. This may vary
according to your beard growth.
4
. For best shaving
clean clean
high high
low low
clean clean
13