Shutting Off the Engine
Service Interval: Before each use or daily—Ensure that the engine shuts off within 3 seconds after releasing
the blade-control bar.
To shut off the engine, release the blade-control bar.
Important:
When you release the blade-control bar, both the engine and blade should stop within 3
seconds. If they do not stop properly, stop using your machine immediately and contact an Authorized
Service Dealer.
Operating the Self-Propel
Drive
This machine has 3 ground speeds: 1 (slow), 2
(medium), and 3 (fast); it also has a Neutral (N)
position. The self-propel-drive lever is located below
and behind the fuel tank
Figure 15
1. Self-propel-drive lever
1.
Move the self-propel-drive lever to the desired
ground speed.
2.
Start the engine.
3.
Squeeze the blade-control bar against the
handle to the Run/Drive position
(Figure
15).
(Figure
16).
1. Handle
2. Blade-control bar in the
Run/Drive position
Important:
the blade-control bar against the handle in
the Run/Drive position could damage the
g024167
transmission. Move the blade-control bar to
the Run/Shift position
you change the ground speed.
Note:
You can vary the ground speed by
increasing or decreasing the distance between
the blade-control bar and the handle. Lower the
bar to decrease the ground speed when you are
making a turn or if the machine is moving too fast
for you. If you lower the bar too far, the machine
stops self-propelling. Squeeze the bar closer to
the handle to increase the ground speed. When
you hold the bar tight against the handle, the
machine self-propels at the maximum ground
speed. Move the self-propel-drive lever to the
N
EUTRAL
for trimming.
16
Figure 16
3. Blade-control bar in the
Run/Shift position—about
5 cm (2 inches) below the
handle
4. Blade-control bar in the
Stop position
Shifting speeds while squeezing
(Figure
position when you use the machine
g024168
16) whenever