Table of Contents
Advertisement
Tools Needed
• Drill and drill bits
• Flat screwdriver
• Wire cutter
• Wire stripper
• 120 A inline fuse or circuit breaker for 12 volt models or 60 A inline fuse or circuit breaker for 24 volt models
2
• 4 AWG (21.1 mm
) power cable
NOTE: You may need thicker cable for higher amperages or longer runs
page 6).
2
• 16 AWG (1.31 mm
) speaker wire
NOTE: You may need thicker wire for longer runs
2
• 20 AWG (0.52 mm
) wire (amplifier turn-on signal)
• Dual RCA cable (1 per zone, for stereo speakers)
• Single RCA cable and RCA splitter (1 per zone, for mono subwoofer or bridged output for speakers)
and Speaker Connection Considerations,
• Cable ties (optional)
Mounting Considerations
In high ambient temperatures and after extended use, the device enclosure may reach temperatures deemed
dangerous to touch. Therefore the device must be installed in a location where it will not be touched during
operation.
This device should be mounted in a location that is not exposed to extreme temperatures or conditions. The
temperature range for this device is listed in the product specifications. Extended exposure to temperatures
exceeding the specified temperature range, in storage or operating conditions, may cause device failure.
Extreme-temperature-induced damage and related consequences are not covered by the warranty.
This device is designed for installation only in a dry location. Installing this device in a location where it may
come in contact with water or become submerged may result in damage. Water damage is not covered by the
warranty.
• The device must be mounted in a location that does not interfere with the fuel tank or electrical wiring.
• The device must be mounted in a location where it is not exposed to water.
• The device must be mounted in a location with adequate ventilation where it is not exposed to extreme
temperatures.
• If the device is mounted in an enclosed space, you should install a cooling fan with appropriate ducts to aid in
airflow.
• The device should be mounted so that the cables can be connected easily.
• To avoid interference with a magnetic compass, the device should be installed at least 55 cm (22 in.) away
from a compass.
• The device should not be mounted in close proximity to other navigation-critical equipment, antennas, or
radio-communication equipment on the vessel.
2
(Speaker Wire Gauge Guide,
(Signal and Speaker Connection Considerations,
page 7)
CAUTION
NOTICE
(Power Cable Gauge Guide,
page 8).
page 7)
(Signal
Advertisement
Table of Contents
