Smart Fan 6 - Gigabyte Z590 AORUS ELITE AX User Manual

2-3

Smart Fan 6

Use the <F6> function key to quickly switch to this screen. This screen allows you to configure fan speed
related settings for each fan header or monitor your system/CPU temperature.
& TUNE ALL
Allows you to apply the current settings to all fan headers.
& Temperature
Displays the current temperature of the selected target area.
& Fan Speed
Displays current fan/pump speeds.
& Flow Rate
Displays the flow rate of your water cooling system. Press <Enter> on Fan Speed to switch to this function.
& Fan Speed Control
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Allows the fan to run at different speeds according to the temperature. You can adjust
Normal
the fan speed with System Information Viewer based on your system requirements.
(Default)
Allows the fan to run at slow speeds.
Silent
Allows you to drag the curve nodes to adjust fan speed. Or you can use the EZ Tuning
Manual
feature. After adjusting the node position, press Apply to automatically calculate the
slope of the curve.
Full Speed Allows the fan to run at full speeds.
& Fan Control Use Temperature Input
Allows you to select the reference temperature for fan speed control.
& Temperature Interval
Allows you to select the temperature interval for fan speed change.
& FAN/PUMP Control Mode
Lets the BIOS automatically detect the type of fan installed and sets the optimal control
Auto
mode. (Default)
Voltage mode is recommended for a 3-pin fan/pump.
Voltage
PWM mode is recommended for a 4-pin fan/pump.
PWM
& FAN/PUMP Stop
Enables or disables the fan/pump stop function. You can set the temperature limit using the temperature
curve. The fan or pump stops operation when the temperature is lower than the limit. (Default: Disabled)
- 27 -