Advertisement
1. Use the BAND SELECTOR (#9) to select the AM or FM band.
2. Turn on the radio by rotating the ON/OFF/VOLUME CONTROL (#6). The Power Indicator
(#5) will turn on.
3. Use the TUNING CONTROL (#4) to tune to your desired radio station.
4. Adjust the ON/OFF/VOLUME CONTROL (#6) to obtain the desired sound level.
5. Rotate the ON/OFF/VOLUME CONTROL (#6) to turn off the radio when finish listening.
TIPS FOR BEST RADIO RECEPTION
AM - The AM antenna is built inside the radio. If AM reception is weak, change the position
of the unit until the internal antenna picks up the strongest signal
FM - To obtain the best FM reception, fully extend the TELESCOPIC FM ANTENNA (#1).
Avoid close to the speakers or other electrical appliance.
Headphones are not supplied with the unit. You will require headphones fitted with a 3.5mm
diameter stereo plug and an impedance of 8-32 ohms. Plug your headphones into the
EARPHONE JACK (#2) on the top of the unit for private listening. When using headphones,
the built-in Speaker will be disconnected.
WARNING : ALWAYS LOWER THE VOLUME LEVEL BEFORE PUTTING ON YOUR
HEADPHONES. OTHERWISE YOUR HEARING COULD BE DAMAGED.
1. Clean the unit with soft cloth. Solvent or detergent should never be used.
2. Avoid operating your unit under direct sunlight.
3. Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
LISTENING TO THE RADIO
USING HEADPHONES
CARE AND MAINTENANCE
E-4
Advertisement
