Advertisement
Quick Links
Advertisement
Related Manuals for Vax Blade 2
Summary of Contents for Vax Blade 2
- Page 1 USER GUIDE VX80...
-
Page 2: Safety Information
Read this user guide completely before using the machine. Keep this user Only Vax recommended charger, guide for reference. If you pass your tools and accessories should be used machine on to third parties, it must with this stick vac and always check be accompanied with this user guide. - Page 3 Safety Always use the charger supplied with the stick vac. If charging the stick This stick vac can be used by vac through an extension cord, use children aged from 8 years and above only SAA approved 10amp extension and persons with reduced physical, cords.
- Page 4 Storage battery pack. Do not use a battery pack or charger Store your stick vac in a cool, dry area. If filters have been cleaned as that has been dropped or received per user guide instructions ensure a sharp blow. A damaged battery is they are thoroughly dry before storing subject to explosion.
- Page 5 The appliance must be disconnected batteries to become contaminated with from the supply mains when ever any material which could removing the battery. be conductive. The battery is to be disposed of Remove the plug of the product safely. from the power socket when it is not in use or when cleaning it.
- Page 6 WELCOME TO VAX Thank you for buying the Vax BLADE 2, we hope you enjoy using your new product. This user guide will help you get the most out of your machine and gives advice on maintenance and cleaning. GET IN TOUCH...
- Page 8 Technical Specification Charger Specification Accessories & Consumables Blade 2 ZD24W340060 Model No. VX82F Name Model number Pre-motor filter VX80 100-240V ~ 50/60Hz Model number Input voltage To purchase consumables and 0.8A Max Battery voltage 29.2V accessories, please visit vax.com.au / Output voltage 34.0V...
- Page 11 40°C 24hr Accessories Crevice Tool Dusting Brush Filter VX82F...
-
Page 12: Getting To Know Your Machine
GETTING TO KNOW YOUR MACHINE 3. Holding the wall bracket securely Fig. 1 against the wall, use a pencil to make a small mark for each screw. (Fig. 5 /2 ) A. Carry handle Use the screws and wall plugs to secure B. - Page 13 When less than 20% charge is remaining 3. To increase suction for particularly the bottom light will flash red indicating dirty areas that require additional cleaning boost mode can be activated (Fig. 9 /3). the battery is running low and charging is required (Fig.
- Page 14 2. Push the tab on the lid of the dirt NOTE: Before refitting, if the lid of the container to access the filter container with separator has been (Fig. 15/1 & 2). Lift the filter cover removed for cleaning make sure the and separator from the dirt container separator has been locked into place (Fig.
-
Page 15: Troubleshooting
top of the large cog and rotate the belt The filters may be clogged. Go to Cleaning the filter and separator. and cog anticlockwise. During rotation the belt will slide onto the cog (Fig. 22/2) There maybe a blockage. Go to Checking for blockages. 3. - Page 16 Distributed by Techtronic Industries Australia Pty Ltd 31 Gilby Road, Mount Waverley, VIC 3149, Melbourne, Australia Careline AU: 1300 VAX AUS (1300 829 287) www.vax.com.au Techtronic Industries N.Z. Limited 2 Landing Drive, Mangere, Auckland, 2022, New Zealand Careline NZ: 0800 VAX NZL (0800 829 695) www.vax.co.nz...