Traxxas XMAXX 77086-4 Owner's Manual page 27

Removing the front suspension module
1. Remove the two 3x20mm cap screws from the front of the chassis
brace.
2. Remove the 3x15mm button-head cap screw from the steering link.
3. Remove the four 4x25mm button-head cap screws from the top of
the chassis.
4. Remove the two 4x14mm button-head cap screws from the chassis
next to the receiver box.
5. Remove the two 4x14mm button-head cap screws from the bottom
of the chassis.
6. Pull the front suspension assembly away from the chassis. Pull the
assembly away firmly.
To reassemble the modules, follow the steps in reverse order. There
will be an audible "click" as the modules are pushed into place.
Removing the rear suspension module
1. Disconnect the three motor wires.
2. Remove the motor heat sink. Carefully remove the temperature
sensor wire from the motor.
3. Remove the two 3x20mm cap screws from the chassis brace.
4. Remove the four 4x30mm cap screws from the top of
the chassis.
5. Remove the four 4x14mm button-head cap screws from the
middle of the chassis next to the motor.
6. Remove the two 4x14mm button-head cap screws from the
bottom of the chassis.
7. Pull the rear suspension assembly away from the chassis. Pull the
assembly away firmly.
8. Remove the Cush Drive Assembly.
To reassemble the modules, follow the steps in reverse order. There
will be an audible "click" as the modules are pushed into place.
MAINTAINING YOUR MODEL
3. 4x25mm
BCS
1. 3x20mm CS
2. 3x15mm
BCS
5. 4x14mm
5. 4x14mm
BCS
4. 4x30mm
BCS
3. 3x20mm CS
6. 4x14mm
BCS
4. 4x14mm
BCS
BCS
X-MAXX • 27