Camera Tracking; Setting The Camera Angle And Height; Using Compass Lock - Garmin GPSMAP 86 Series Owner's Manual

Camera Tracking

When connected to the proper cameras, these GPSMAP chartplotter models support camera tracking.
• 8600
• 8700
• 7x3 / 9x3 / 12x3
• 10x2 / 12x2 Keyed
• 12x2 Touch
You can use the camera tracking feature either to hold the camera on a fixed compass direction (Compass
Lock) or to lock onto a specific vessel or target location (Vessel Lock), also known as slew-to-cue.
To use the camera tracking features, you must connect specific sensors and cameras to the chartplotter using
the Garmin Marine Network or the NMEA 2000 network.
To support Compass Lock, you must connect these sensors and cameras.
• A tracking-capable marine camera such as a newer model FLIR IP video camera
• A GPS antenna
• A heading sensor
NOTE: For the best camera tracking performance, the heading sensor should provide 9-axis data including
yaw, pitch, and roll.
In addition to the sensors and cameras needed to support Compass Lock, you must connect these additional
devices to the Garmin Marine Network to support Vessel Lock.
• To track vessels or targets using MARPA, you must connect a compatible radar device.
• To track vessels or targets using AIS, you must connect a compatible AIS receiver.

Setting the Camera Angle and Height

If the camera supports camera tracking and the required equipment is connected, you should configure the
camera angle and height for the best results when using the camera tracking feature.
You should make small adjustments until the camera view and camera tracking performance work as expected.
• The Camera Angle value specifies the angle at which the front of the camera points relative to the front of the
boat. A Camera Angle of zero degrees indicates the front of the camera is aligned with the front of the boat.
• The Camera Height value specifies how high the camera is mounted above the heading sensor.
• To set the camera angle, select Vessel > Video > Options > Installation > Camera Angle, and enter a value.
• To set the camera height, select Vessel > Video > Options > Installation > Camera Height, and enter a value.

Using Compass Lock

Your tracking-capable camera can lock onto a compass direction regardless of the vessel heading. Using
Compass Lock requires specific sensors and devices
1 If necessary, from a video screen, select Options > Source, and select a compatible camera.
2 Drag the screen to aim the camera in the desired direction.
3 Select Options > Target Tracking > Compass Lock.
4 Select Back until you return to the video screen.
The camera view automatically adjusts to show the specified direction as the vessel moves.
5 If necessary, drag the screen to adjust the camera angle.
The Compass Lock continues to track using the adjusted camera angle.
6 To stop tracking, select Options > Target Tracking > Stop Tracking > Back.
160
(Camera Tracking, page 160).
Viewing Video