Table of Contents
Advertisement
2-1
Overview
This chapter covers the setup and installation of the MicroBlade and its components.
2-2
Installing MicroBlades
Up to twenty-eight MBI-6219B-TxxN MicroBlade may be installed into a single
MBE-628E-xxx and MBE-314E-xxx MicroBlade enclosure. MicroBlades with Windows
and Linux operating systems may be mixed together in the same blade enclosure.
Powering Up a MicroBlade Unit
Each MicroBlade unit may be powered on and off independently from the rest of the
MicroBlades installed in the same enclosure. A MicroBlade unit may be powered up in
two ways:
•
Press the power button on the MicroBlade unit.
•
Use IPMIView or the web-browser based management utility to apply power using
the CMM MicroBlade.
Powering Down a MicroBlade Unit
A MicroBlade unit may be powered down in any of the following ways:
•
Press the power button on the MicroBlade unit.
•
Use IPMIView or the web-browser based management utility to power down (if you
have Operator or Admin privileges on the CMM).
•
Use IPMItool when connected to the CMM to power down (if you have Operator or
Admin privileges on the CMM).
Chapter 2
Setup and Installation
2-1
Advertisement
Table of Contents
