Starting / Stopping The Engine - Stihl ROLLOMATIC E MS 651 Instruction Manual

English
At temperatures below -10 °C
Under extreme winter conditions
(temperatures below -10 °C, powdered
or drifting snow), it is recommended to
mount the cover plate (special
accessory) on the fan housing.
The partial covering of the slits in the fan
housing keeps out powdered or drifting
snow.
In case of erratic idling behaviour or poor
acceleration
Turn the low speed screw (L)
N
1/4 turn counterclockwise
Whenever the low speed screw (L) has
been adjusted, it is usually also
necessary to adjust the idle speed
screw (LA), see "Setting the
carburettor".
If the chain saw is extremely cold
N
(frost formation) – after starting,
bring the engine up to operating
temperature at increased idle speed
(disengage chain brake!)
26
Mounting the cover plate (special
accessory)
2
2
1
Insert cover plate (1) with both tabs
N
(arrows) and snap it onto the fan
housing
Screw in screws (2)
N
When the mounting kit is used, the slide
must be in the winter position.
If engine trouble occurs, first check
whether use of the cover plate is
necessary.
Starting / Stopping the
Engine
Positions of Master Control Lever
STOP
0
Stop 0 – engine off – the ignition is
switched off
Normal run position (F) – engine runs or
can fire.
Warm start (n) – this position is used to
start a warm engine.
Cold start (l) – this position is used to
start a cold engine.
Setting the Master Control Lever
To move the Master Control lever from
the normal run position (F) to cold start
(n), press down the throttle lockout and
squeeze the throttle trigger at the same
time.
MS 651