Kenwood TK-3406 Instruction Manual page 15

■ Key Lock with Status Memory
This operates the same as Key Lock except that when the
transceiver power is turned OFF and then ON again, the
keys remains locked.
■ Lone Worker
Lone Worker Mode is a safety feature built into the transceiver.
If the transceiver is not operated for a pre-programmed period
of time, the transceiver will emit a tone and automatically enter
Emergency operation.
Press this key to toggle the Lone Worker function ON or OFF.
■ Low Transmit Power
Each channel is programmed with either high or low
transmit power. On high transmit power channels, press
this key to change the transmit power to low power (you
cannot change low transmit power channels to use high
power).
■ Monitor
Press this key to deactivate signaling (QT/DQT, FleetSync
signaling, etc.). Press the key again to return to normal
operation.
■ Monitor Momentary
Continuously hold down this key to deactivate signaling
(QT/DQT, FleetSync signaling, etc.). Release the key to
return to normal operation.
■ Paging Call
Press this key to send a FleetSync paging call to an ID from
the ID list.
■ Priority-channel Select
If the scan priority type is "Operator Selectable", press
this key in normal mode to set the current channel as the
priority channel.
■ Scan
Press this key to start scanning the transceiver channels.