Toro Groundsmaster 4010-D Operator's Manual page 18

Hi-Lo Speed Control
The switch (Figure 4) allows the speed range to increase for
transport of the machine. Cutting decks will not operate
in high range. To switch between the High and Lo range,
the decks must be raised, PTO disengaged, cruise control
disengaged, traction pedal in neutral position and the machine
must be moving at a slow speed.
Lift Switches
The lift switches (Figure 4) raise and lower the cutting
units. Press the switches forward to lower the cutting units
and backward to raise the cutting units. When starting the
machine, with the cutting units in the down position, press the
lift switch down to allow the cutting units to float and mow.
Note: The decks will not lower while in the HI speed range
and they will not raise or lower if the operator is out of the
seat when the engine is running. Also, the decks will lower
with the key in the On position and the operator in the seat.
Power Point
The power point (Figure 5) is used to power optional electrical
accessories.
1. Power point
Seat Adjustments
Fore and Aft Adjusting Lever
Pull out on the lever to slide the seat fore or aft
Seat Arm Rest Adjusting Knob
Rotate the knob to adjust the seat arm rest angle
Seat Back Adjusting Lever
Move the lever to adjust the seat back angle
Figure 5
(Figure
(Figure
(Figure
Weight gauge
Indicates when the seat is adjusted to the weight of the
operator (Figure
the suspension within the range of the green region.
1. Weight gauge
2. Weight adjusting lever
3. Fore and Aft adjusting
lever
Weight Adjusting Lever
Adjust for operator weight
increase the air pressure and push down to decrease the air
pressure. The proper adjustment is attained when the weight
gauge is in the green region.
g020443
Cab Controls
Cab model only
Wind Shield Wiper Switch
Press front of switch to activate the wind shield wipers
(Figure 7) and rear of switch to turn off the wipers.
6).
Air Conditioning Switch
Press front of switch to activate the air conditioning
7) and rear of switch to turn off the air conditioning.
6).
Fan Control
Rotate the fan control knob to regulate the speed of the fan
6).
(Figure 7).
18
6). Height adjustment is made by positioning
Figure 6
4. Seat back adjusting lever
5. Arm rest adjusting knob
(not shown-located under
arm rest)
(Figure 6). Pull up on the lever to
g008837
(Figure