Advertisement
Wall mounting
Remove the breakout on the housing before putting the cable into the gaining channel.
4-wire cables
(daisy chain wiring)
Cable ducts on the wall
Dismounting / service:
6 / 16
QMX3... Wall-mounted sensors and room operator units for KNX PL-Link, KNX S-mode and KNX LTE-Mode
Siemens Smart Infrastructure
30 mm
Remove the cable coating, as it will not fit in
the gaining channel.
Keep a distance of 30 mm (from above) /
20 mm (from below) to the base plate,
so that the device can be snapped onto the
base plate.
CM2N1602en_08
2020-04-03
Advertisement
