HP DreamWorks Shrek 3-D puss in boots Assembly Instructions

3-D puss in boots
ASSEMBLY INSTRUCTIONS
Time to complete: Approximately 45 minutes
GETTING STARTED
Materials
• Metal-edged ruler
• Butter knife
• Scissors or craft knife
• Cutting mat (optional)
• Multipurpose glue
Hey kids,
make sure to ask
an adult for help!
ASSEMBLE YOUR PUSS IN BOOTS
Hat feather, feet, hat brim, arms, and tail:
4
Fold pieces in half and glue together.
Cut out shapes along solid gray lines.
Body: Starting at the top, glue tabs on side body panels to front body panel.
6
Then, glue tabs on back body panel to each side body panel.
To close top and bottom of body, fold in tabs and glue in place.
Shrek Forever After ™ & © 2010 DreamWorks Animation L.L.C.
Shrek is a registered trademark of DreamWorks Animation L.L.C.
Level: Medium
1
Score all the pieces: Using
a ruler as a guide, run the
back side of a butter knife
firmly along all dashed and
dotted lines.
5
2
Using scissors or a craft
knife and cutting mat, cut
out pieces along solid
lines. Don't forget to cut
slits on the body piece.
Tail: Insert (from non-printed side) into slit on back of body.
Glue tabs to inside of body.
©2010 Hewlett-Packard Company hp.com/create
3
Fold all pieces along
score lines, using the
folding key below as a
reference.
Mountain Fold
Valley Fold