Table of Contents
Advertisement
Seat Belts
This POLARIS vehicle is equipped with three-point lap and diagonal
seat belts for all riders. Always make sure the seat belts are secured for
the operator and passenger before riding.
To wear the seat belt properly, follow this procedure:
1. Pull the seat belt latch downward and across your chest toward the
buckle at the inner edge of the seat. The belt should fit snugly across
your hips and diagonally across your chest. Make sure the belt is not
twisted.
2. Push the latch plate into the buckle until it clicks.
3. Release the strap, it will self-tighten.
4. Press the red release latch on the buckle to release the seat belt.
Seat Belt Inspection
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate
must slide smoothly into the buckle. A click indicates that it's
securely latched.
2. Push the red release latch in the middle of the buckle to make sure it
releases freely.
3. Pull each seat belt completely out and inspect the full length for any
damage, including cuts, wear, fraying or stiffness. If any damage is
found, or if the seat belt does not operate properly, have the seat belt
system checked and/or replaced by an authorized POLARIS dealer.
4. To clean dirt or debris from
the seat belts, sponge the
straps with mild soap and
water. Do not use bleach,
dye or household
detergents.Use a garden
hose to flush out the
retractor and latch housings
regularly.
FEATURES AND CONTROLS
Latch Housings
Retractor
Housing
29
Advertisement
Table of Contents
