Advertisement
Mounting Sensor Shield
Mount to a flat surface:
Twist the cover clockwise to remove the base.
Place one long screw through the center hole of the base.
Tighten until the head of the screw is flat with the base.
Do not overtighten.
Mount to a wall or post:
Slide the mounting bracket down and remove from the cover.
Take note of the UP ARROW on the back of the bracket.
Find a shaded location and attach the bracket (arrow UP) with the four
screws (included), or with the two zip ties (included).
Note: Allow room to slide cover onto bracket.
Slide the shield down onto the bracket.
Insert a Sensor
Twist the cover clockwise to remove the base.
Attach the Velcro tape to the sensor and to the upright on the base. This
keeps the sensor from tipping.
Alternately, secure the sensor with a zip tie.
With a probe sensor, be sure the probe wire fits through the round hole in
the base.
Place cover over sensor and base. Twist counter clockwise to lock into
place. Sensor must fit entirely in the sensor shield to be protected.
Mount the sensor shield so that the sensor is in range of the display.
SPECIFICATIONS
Dimensions:
Sensor Weather Shield
WARRANTY AND SUPPORT
La Crosse Technology, Ltd. provides a 1-year limited time warranty (from date of
purchase) on this product relating to manufacturing defects in materials &
workmanship.
View full warranty details online at:
www.lacrossetechnology.com/warranty_info.pdf
For warranty work, technical support or other information contact out friendly
support staff:
La Crosse Technology, Ltd
th
2830 South 26
St
La Crosse, WI 54601
Contact Support:
1-608-782-1610
Online Product Support:
www.lacrossetechnology.com/support
Model: 925-1418
7.00" H x 3.73" W x 3.98" D (177.8 x 94.74 x 101.9 mm)
Product Registration:
www.lacrossetechnology.com/support/register
www.lacrossetechnology.com/support
Page | 2
Advertisement
