Advertisement
3.1.5 Remove the switching regulator board (See figure 9)
• Prior to performing the following procedure, remove the top
cover.
(1) Disconnect the card wire from connector
switching regulator board.
(2) Disconnect the socket wire from connector CN5303,
CN5305, CN5306,
CN5307
board.
(3) Disconnect the power cord from connector
switching regulator board.
(4) Remove the two screws G attaching the switching regula-
tor board.
(5) Four spacers are removed.
3.1.6 Remove the main board (See figure 10, figure 11)
• Prior to performing the following procedure, remove the top
cover, drive unit, digital board, switching regulator board, HDD.
(1) Disconnect the card wire from connector CN3001,
CN3002, CN4001,
CN7301
(2) Remove the two screws H attaching the main board.
(3) Remove the seven screws I attaching the rear panel with
main board.
1-12 (No.YD026)
CN5301
on the
on the switching regulator
CN5001
on the
on the main board
Spacer
Spacer
CN5303
CN5301
CN5307
CN5306
Spacer
CN5305
Fig.9
CN4001
CN3002
H
CN7301
Fig.10
Rear panel
I
Fig.11
Switching
Spacer
regulator board
CN5001 G
G
Power cord
H
CN3001
Main board
Advertisement
