Westinghouse PWSG 3200 PSI 50-FOOT EXTENSION HOSE Installing

PWSG 3200 PSI 50-FOOT EXTENSION HOSE
FOR WESTINGHOUSE PRESSURE WASHERS
WARNING
User must read and understand the operator's manual for their pressure
washer before using this accessory to reduce the risk of injury. Fits
most pressure washers. Before using this attachment, make sure it is
compatible and is correctly installed. Risk of fluid injections. Do not point
at people, pets, electrical devices, or the unit itself. Wear eye protection
designated to conform with ANSI Z87.1. Before adding, replacing, or
modifying accessories, turn off the pressure washer, release the water
pressure in the trigger handle, and lock the trigger handle's lock out (if
one is provided with your pressure washer). Use only with cold water
and only outdoors. Store the accessory indoors.
INSTALLING THE HIGH PRESSURE HOSE
See Figure 1.
l Thread the collar of the high pressure hose clockwise onto the trigger
handle's coupler. Be careful not to cross-thread.
l Pull on the hose to be certain it is secure.
WARNING
Hold the trigger handle securely with both hands when the unit is on to
reduce the risk of injury from kickback.
Service Hotline: (855) 944-3571
777 Manor Park Drive, Columbus, OH 43228
and Westinghouse are trademarks of Westinghouse Electric Corporation.
Used under license by MWE Investments, LLC.
© 2022 MWE Investments, LLC All Rights Reserved.
05000420-0 12/22 (REV:01)
FIG. 1
A - High pressure hose (manguera de alta presión, tuyau haute pression)
B - Collar (collar, collier)
B
A