Lennox PUREAIR PCO14-23 Installation Instructions Manual

E2009 Lennox Industries Inc.
Dallas, Texas, USA
INSTALLATION INSTRUCTIONS FOR PUREAIRT AIR PURIFICATION SYSTEM
RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE
Shipping & Packing List
Assembled PureAirt air purification system which in-
cludes:
1 − Cabinet
1 − Control box assembly (includes frame, ballasts
and associated wiring)
1 − MERV 16 pleated filter
2 − UVA lamps
1 − Titanium dioxide metal insert
1 − Power cord (120VAC)*
*230VAC power cord available separately (part number
91X44).
A warranty certificate and registration card are also in-
cluded.
Shipping Damage
Check equipment for shipping damage. If damage is
found, immediately contact last carrier.
General Information
The PureAirt air purification system uses photocatalytic
oxidation (PCO) technology to significantly reduce levels
of airborne volatile organic compounds, cooking odors,
common household odors, airborne dust particles, mold
spores and pollen. The PureAirt system is available in
three models: PCO14−23, PCO16−28 and PCO20−28.
Each unit may be connected to either 120VAC or 230VAC
power supply. If 230VAC power supply is used, a 230VAC
power cord must be ordered separately.
Lab tests confirm a 50% reduction in total volatile organic
compounds (TVOC) within the first 24 hours of initial op-
eration of the PureAirt air purification system. It may take
up to 48 hours after initial system start−up to reduce the air-
borne chemicals that have built up in a home over a long
period of time.
For peak performance, unit should be installed in homes
with TVOC levels that are less than 1000 µg/m
source removal and ventilation may be required to lower
TVOCs to this level.
10/09
*2P1009*
AIR CLEANERS / FILTERS
505,276M
10/09
Supersedes 07/09
MODELS PCO14−23, PCO16−28 AND PCO20−28
3
. Home
Page 1
PUREAIRt AIR PURIFICATION SYSTEM
PHOTOCATALYTIC OXIDATION (PCO)
This system is NOT intended to be used for removal
of active mold growth or continuous sources of
high levels of chemicals in the air.
For existing mold growth, the mold must be proper-
ly removed PRIOR to installation of the PureAirt air
purification system.
Risk of property damage, injury, or death.
Installation and service must be performed by a
qualified installer or service agency.
Electric shock hazard.
Can cause injury or death.
Disconnect all electrical power supplies before ser-
vicing. Access panels must be in place during ap-
pliance operation.
Sharp edges hazard.
Sharp edges can cause injuries.
Use protective gloves when grasping equipment
edges.
Possible odor emissions. Chemical reactions may
cause temporary odors after initial start−up or after
lamp replacement. Odor may also be present after
paint, cleaning solutions or hobby materials have
been used in the conditioned space.
Some occupants may experience irritation or dis-
comfort during this period. If the irritation or dis-
comfort lasts longer than 48 hours, the homeowner
should be advised to contact a Lennox dealer.
Unique Field−Supplied Installation Items
S
Cotton gloves and cloth (to remove fingerprints from
lamps)
S
Aluminum foil tape or water−based mastic (NOT sili-
cone) to be applied as a sealant.
TECHNOLOGY
NOTICE
WARNING
WARNING
CAUTION
NOTICE
505,276M
*P505276M*
Litho U.S.A.