Table of Contents
Advertisement
!
NOTE
Avoid keeping a fixed image on the set's screen for
G
prolonged periods of time. The fixed image may
become permanently imprinted on the screen; use a
screen saver when possible.
There may be interference relating to resolution, ver-
G
tical pattern, contrast or brightness in PC mode.
Change the PC mode to another resolution or change
the refresh rate to another rate or adjust the bright-
ness and contrast on the menu until the picture is
clear. If the refresh rate of the PC graphic card can not
be changed, change the PC graphic card or consult
the manufacturer of the PC graphic card.
The synchronization input waveform for Horizontal
G
and Vertical frequencies are separate.
Connect the signal cable from the monitor output
G
port of the PC to the RGB (PC) port of the TV or the
signal cable from the HDMI output port of the PC to
the HDMI IN (or HDMI/DVI IN) port on the TV.
Connect the audio cable from the PC to the Audio
G
input on the TV. (Audio cables are not included with
the TV).
If using a sound card, adjust PC sound as required.
G
If the graphic card on the PC does not output ana-
G
logue and digital RGB simultaneously, connect only
one of either RGB or HDMI IN (or HDMI/DVI IN) to
display the PC output on the TV.
If graphic card on the PC does output analogue and
G
digital RGB simultaneously, set the TV to either RGB
or HDMI; (the other mode is set to Plug and Play
automatically by the TV.)
DOS mode may not work depending on the video
G
card if you use a HDMI to DVI cable.
If you use too long an RGB-PC cable, there may be
G
interference on the screen. We recommend using
under 5m of cable. This provides the best picture
quality.
When an unsupported resolution or graphic card is
G
used on the PC, it may cause some errors.
We recommend using 1920x1080, 60Hz(only
G
22/26/32/37/42LH2*** : 1360x768, 60Hz) for the
PC mode, this should provide the best picture
quality.
31
Advertisement
Table of Contents
