Electrical Adjustment Procedures - JVC HR-V205EF Service Manual

Video cassette recorder
Hide thumbs Also See for HR-V205EF:
Table of Contents

Advertisement

ELECTRICAL ADJUSTMENT PROCEDURES

1. Servo Adjustment
1) PG Adjustment
• Test Equipment
a) OSCILLOSCOPE
b) PAL TEST TAPE (VHS SP)
c) JIG REMOCON (AUTO PG SETTING)
• Adjustment And Specification
MODE
PLAY
• Adjustment Procedure
a) Insert the PAL SP Test Tape and play.
Note - Adjust the distance of X, pressing the Tracking(+) or Tracking(-) when the "ATR" is blink after the
PAL SP Test Tape is inserted.
b) Press the Auto PG KEY on JIG Remocon(1'st) or Press "REC" key on set and "CLEAR" key on
Remocon.(Then check the blink "TRK OK" on CLK/LED-TRK is a Initial)
c) Press the Auto PG Key on JIG Remocon again (2'nd) or press "REC" key on set and "CLEAR" key on
Remocon again.(Then check the blink "PG NG > PG OK" on CLK/LED.)
• Check the PG
a) Connect the CH1 of the oscilloscope to the H/SW and CH2 to the Video out for the VCR.
b) Trigger the mixed Video Signal of CH2 to the CH1 H/SW(W501, W502), and then check the distance
(time difference), which is from the selected A(B) Head point of the H/SW(W501, W502) signal to the
starting point of the vertical synchronized signal, to 6.5H ± 0.5H (416µs, 1H=64.0µs).
• CONNECTION
MEASUREMENT POINT
V.Out
H/SW(W501, W502)
V.Out
H/SW(W501,W502)
ADJUSTMENT POINT
OSCILLOSCOPE
(W501, W502)
3-2
SPECIFICATION
6.5 ± 0.5H
CH1 CH2
H/SW
V.out

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hr-v206elHr-v206exHr-v206eyHr-v505ef

Table of Contents