Advertisement
2. Installation
Unpacking
Remove the package of the pro-
duct and, to remove the base of
the package, carefully incline the
refrigerator to one of the sides.
With the help of another person,
break the base with your hands.
Incline the refrigerator to the
other side and remove the rest
of the base.
In the back of the refrigerator,
remove the adhesive tapes and
unlock the two back spacers. Let
them in the horizontal position.
Before turning the refrigerator on, remove the
shim of the doors, the shim of the compressor
located in the back part and also remove the
base of the package.
Choose the Location
Install your refrigerator in a ventilated location
away from direct sunlight and heat sources (stove,
ovens, etc.) and flammable products.
Do not install your refrigerator unsheltered (open
to weather).
For the definite position of the refrigerator, respect
the minimum distances recommended:
- On top: 10 cm
- Side: 10 cm
- Behind: 10 cm
Check if the spaces
left in the front of the
fridge and in the right
side (looking at the
front of the fridge) are
enough to allow complete opening of the door and
crisper drawer.
Leveling
Set the leveling feet to ensure
perfect refrigerator stability, pre-
venting rocking movement. For
a better closing of the doors, we
recommend the product to be
inclined back.
The proper functioning of the refrigerator shall
depend on its perfect leveling.
ATTENTION
Your refrigerator was developed to use the
leveling feet, which come with it.
Therefore, do not use other feet other than the
original. There are wheels on the back part of
your refrigerator to facilitate movement.
After unpacking and leveling, wait at least two
hours before connecting your refrigerator to
prevent malfunctioning.
Electrical Installation
Before turning your fridge on re-
move the transparent protective
wrapping plastic applied on the
control panel in the freezer door.
Before connecting your refrige-
rator, check if the voltage on the
socket where it will be plugged
is equal to the one indicated on
the label next to the plug (on the
power cable) or on the refrigera-
tor ID label.
Be careful not to leave the refrige-
rator over the power cable.
Connect the refrigerator to an
exclusive socket. Do not use
extensions or T-connectors.
For your safety, request an elec-
trician of your trust to check the
condition of the electrical power
system at the location it will be
plugged and for further infor-
mation, contact the Technical
Service.
The socket wires where your
refrigerator will be connected
should be of copper and have
a minimum section of 2.5 mm².
Admissible voltage variation
Voltage (V)
Minimum (V) Maximum (V)
127
220
116
133
201
231
3
Advertisement
