Inspection - MULTIQUIP QP2TB Operation Manual

Trash pump
Table of Contents

Advertisement

CAUTION
DO NOT attempt to operate the pump
until the Safety Information, General
Information, and Inspection sections
of this manual have been thoroughly
read and understood.
BEFORE STARTING
1. Read the safety instructions at the beginning of this
manual.
2. Clean the pump, particularly the engine cooling air
inlet. Remove all dirt and dust.
3. Inspect the air cleaner for dirt and dust. If the air cleaner
is dirty, replace the filter with a new one as required.
4. Inspect the carburetor for external dirt and dust. Clean
with dry compressed air as needed.
5. Inspect all fastening nuts and bolts for tightness.
ENGINE OIL CHECK
1. Place the pump on secure, level ground with the
engine OFF.
2. Remove the dipstick (Figure 5) from its holder and
wipe it clean.
DIPSTICK
Figure 5. Engine Oil Dipstick
3. Reinsert the dipstick, then remove it again and check
the oil level shown on the dipstick (Figure 5). The
correct oil level is at the top of the full indicator on the
dipstick.
QP2TB TRASH PUMP • OPERATION MANUAL — REV. #0 (11/30/22)— PAGE 15
ADD
ADD
FULL
OIL
LIMIT
4. If the oil level is low, remove one of the oil filler caps
(Figure 6) and fill with the recommended oil type
listed in Table 6. DO NOT overfill. Maximum engine oil
capacity is 0.63 quarts (0.6 liters).
Figure 6. Oil Filler Caps
Table 6. Recommended Oil Viscosity Grades
SAE 5W-30
SAE SYNTHETIC 5W-30
VANGUARD SYNTHETIC 15W-50
–20
0
20
–30
–20
–10
AMBIENT TEMPERATURE
FUEL CHECK
Remove the fuel filler cap and inspect the fuel level in
the tank. If fuel is low, replenish with 87 octane or higher
unleaded gasoline. Maximum fuel capacity is 0.82 gallons
(3.1 liters).
DANGER
Motor fuels are highly flammable and
can be dangerous if mishandled. DO NOT
smoke while refueling. DO NOT attempt to
refuel while the engine is running or hot!
WARNING
ALWAYS use a strainer for filtration while refueling.
NEVER top off fuel. ALWAYS wipe up any spilled fuel
immediately.

INSPECTION

OIL FILLER
CAPS (3)
SAE 30
SAE 10W-30
40
60
80
100°F
0
10
20
30
40°C

Advertisement

Table of Contents
loading

Table of Contents