Table of Contents
Advertisement
[Aging Mode]
This mode can be used for operation check of tape deck section.
Tape deck section work in parallel.
• If an error occurred:
The aging operation stops and display then status.
• If no error occurs:
The aging operation continues repeatedly.
Procedure:
1. Load the tapes into the decks A and B respectively.
[FUNCTION]
2. Press the
[PLAY MODE]
3. Press the
[REPEAT]
and press the
4. Press three buttons of
[DISC 4]
and
simultaneously.
LekSound.net
5. The aging mode is activated, if the indicator of disc tray num-
ber on the fluorescent indicator tube is blinking.
6. To exit from the aging mode, press the
power OFF and operate the cold reset. (Refer to the "MC Cold
Reset")
1. Display at the Aging Mode
• Display operating state of tape deck section alternately.
• If an error occurred, stop display.
LekSound.net
LekSound.net
button to select the function "CD".
button to set the "ALL DISCS" mode,
button to "REPEAT" off.
[
/CLOCK SET]
[ENTER/NEXT]
,
c
button to turn the
?/1
2. Tape Deck Section
• The sequence during the aging mode is following as below.
• If an error occurred, stop display that step.
Aging mode sequence (Tape deck section) :
Rewind the tape A and B
"TAPE A AG-1"
FWD play the tape A
"TAPE A AG-2"
,
Fast forward the tape A
"TAPE A AG-3"
REV play the tape A
"TAPE A AG-4"
Rewind the tape A
"TAPE A AG-5"
FWD play the tape B
"TAPE B AG-2"
Fast forward the tape B
"TAPE B AG-3"
REV play the tape B
"TAPE A AG-4"
Rewind the tape B
"TAPE B AG-5"
Note: "TAPE
AG-
" is display of each step.
*
*
Shut off
2 minutes
Shut off or 20 seconds
2 minutes
Shut off
2 minutes
Shut off or 20 seconds
2 minutes
Shut off
11
Advertisement
Table of Contents
