Specifications; Amplifier Section; Input Section - JL Audio XDM1000/1 Owner's Manual

SPECIFICATIONS

Amplifier Section

Amplifier Topology
Power Supply Type
Minimum Copper
Power/GND Wire
Recommended Fuse
Rated RMS Power @ 14.4V,
<1% THD+N
Rated RMS Power @ 12.5V,
<1% THD+N
Frequency Response
S/N Ratio
(A-weighted, 20 Hz–20 kHz
noise bandwidth)
Damping Factor

Input Section

Number of Inputs
Input Type
Input Voltage Range
Signal Processing
Filter Type
Remote Level Control
Dimensions
L x W x H
Due to ongoing product development, all specifications are subject to change without notice.
NexD™ Ultra-High Speed Class D
Unregulated MOSFET Switching
4 AWG
(Note: CCA/Copper Clad Aluminum wire is not recommended.)
80 A
600W x 1 @ 4 Ω
500W x 1 @ 4 Ω
7 Hz – 500 Hz (+0, -1dB)
>83 dB (Referred to rated power),
>53 dB (Referred to 1 W)
>1000 / 50 Hz @ 4 Ω, >500 / 50 Hz @ 2 Ω
2 (One Stereo Pair)
Differential-Balanced with RCA jack inputs
200mV – 4V RMS
Active, 12dB or 24dB/octave Low-Pass, (50 – 500 Hz), defeatable
HD-RLC or MHD-RLC (optional). Full mute to 0 dB range.
14.73 in. x 7.09 in. x 2.05 in. (374 mm x 180 mm x 52 mm)
800W x 1 @ 3 Ω
650W x 1 @ 3 Ω
1000W x 1@ 2 Ω
800W x 1@ 2 Ω
7