Using The Remote Control - LG UltraGear 27GR95QE-B User Manual

USING THE REMOTE CONTROL

Replacing the Remote Control Battery
1 Remove the screw and open the battery cover.
2
Place the replacement battery (CR2025/ 3 V) matching
label inside the compartment.
3 Close the battery cover and tighten the screw.
To remove the battery, perform the installation actions in reverse.
The illustrations may differ from the actual accessories.
16
direction the
2
(Power) Turns the monitor on or off.
(Input) Selects the input mode.
(Volume) Adjusts the volume.
(Mute) Mute all sounds.
(Brightness) Adjusts the brightness level.
(Previous) Go to the previous step.
Makes the main menu screen appear or
disappear.
(Reader mode) Changes to Reader mode.
1
CAUTION
•
Do not mix old and new batteries, as this may damage the remote control.
•
Be sure to point the remote control toward the remote control sensor on the monitor.
• The product' s internal and external batteries should not be exposed to excessive heat such as direct sunlight,
fire, or the like.
• Risk of fire or explosion if the battery is replaced by an incorrect type.
•
Do not ingest battery. Chemical burn hazard.
(Direction and OK buttons)
You can move, select, and adjust the menu.
* (Down): Enters the [Accessibility] menu if no other OSD (On
Screen Display) is displayed.
(User-defined Key) Enters the menu user specified.
(OLED Care) Enters the [OLED Care] menu.
([DTS Headphone:X]) Selects the desired sound setting.
(Sound Out) Changes the audio output method.