Notes On Schematic Diagram; Types Of Transistor - Sharp CD-C250X BK Service Manual

. Resistor:
To differentiate the Units of resistors, the symbol as K and M
are used: the symbol K means 1000 ohm and the symbol M
means 1000 kohm and the resistor without any symbol is an
ohm resistor. The resistor designated " Fusible" is a fuse type
resistor.
Capacitor:
l
To indicate the unit of capacitor, a symbol P is used: this
symbol P means pica-farad and the unit of the capacitor
without such a symbol is microfarad. As to electrolytic capaci-
tor, the expression " capacitance/withstand voltage" is used.
(CH), (TH), (RH), (UJ): Temperature compensation
(ML): Mylar type
(P.P.): Polypropylene type
Schematic diagram and Wiring Side of P.W.Board for this
l
model are subject to change for improvement without prior
notice.
I I
K R A 1 0 2 M
KTC3199 GR
Figure 22 TYPES OF TRANSISTOR AND LED
. The indicated voltage in each section is the one measured by
Digital Multimeter between such a section and the chassis
with no signal given.
2. In the main section, a tape is being played back.
3. In the deck section, a tape is being played back.
4. In the power section, a tape is being played back.
5. In the CD section, the CD is stopped.
Parts marked with " A n ( r - - 1 ) are important for
l
maintaining the safety of the set. Be sure to replace these
parts with specified ones for maintaining the safety and
performance of the set.
FOOL PROOF
F.
SWM4 A. S.
SWM5 CAM
OFF
OFF
OFF