Table of Contents
Advertisement
TG171xBXUE(en).book Page 27 Monday, September 5, 2016 9:52 AM
Caller ID
Problem
Caller information is not displayed.
Caller information is slow to display.
Time on the unit has shifted.
Liquid damage
Problem
Liquid or other form of moisture has
entered the handset/base unit.
Caution:
L To avoid permanent damage, do not use a microwave oven to speed up the drying process.
Useful Information
Cause/solution
L You must subscribe to a Caller ID service. Contact
your service provider/telephone company for details.
L If your unit is connected to any additional telephone
equipment, remove and plug the unit directly into the
wall jack.
L If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit
and the telephone line jack. Contact your DSL/ADSL
provider for details.
L Other telephone equipment may be interfering with
this unit. Disconnect the other equipment and try
again.
L Depending on your service provider/telephone
company, the unit may display the caller's
information at the 2nd ring or later.
L Move closer to the base unit.
L Incorrect time information from incoming Caller ID
changes the time. Set the time adjustment to
"Manual" (off) (page 16).
Cause/solution
L Disconnect the AC adaptor and telephone line cord
from the base unit. Remove the batteries from the
handset and leave to dry for at least 3 days. After the
handset/base unit are completely dry, reconnect the
AC adaptor and telephone line cord. Insert the
batteries and charge fully before use. If the unit does
not work properly, contact an authorised service
centre.
27
Advertisement
Table of Contents
