Table of Contents
Advertisement
CLEANING AND CARE
Filter Reset (ECONOMY indicator lamp fl ashing/ A special setting)
Can be used if set correctly during installation.
●
Please consult authorized service personnel when using this function.
• It lights on when it is time to clean the air fi lters.
After turning the power on, press the
MANUAL AUTO button for 2 seconds or
less on the indoor unit.
TROUBLESHOOTING
Instructions relating to heating (*) are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).
WARNING
Before requesting service, perform the following checks:
Symptom
NORMAL
Does not operate
FUNCTION
immediately:
Noise is heard:
Smells:
Mist or steam are
emitted:
Airfl ow is weak or
stops:
In the event of a malfunction (burning smell, etc.), immediately stop operation, disconnect the power
supply plug or turn off the circuit breaker, and consult authorized service personnel. Merely turning off
the unit's power switch will not completely disconnect the unit from the power source. Always be sure to
disconnect the power supply plug or turn off your circuit breaker to ensure that power is completely off.
If the unit is stopped and then immediately started again, the compressor will
●
not operate for about 3 minutes, in order to prevent fuse blowouts.
Whenever the power supply plug is disconnected and then reconnected to a
●
power outlet, the protection circuit will operate for about 3 minutes, prevent-
ing unit operation during that period.
During operation and immediately after stopping the unit, the sound of water
●
fl owing in the air conditioner's piping may be heard. Also, noise may be par-
ticularly noticeable for about 2 to 3 minutes after starting operation (sound of
coolant fl owing).
During operation, a slight squeaking sound may be heard. This is the result
●
of minute expansion and contraction of the front panel due to temperature
changes.
*
During heating operation, a sizzling sound may be heard occasionally. This
●
sound is produced by the automatic defrosting operation.
Some smell may be emitted from the indoor unit. This smell is the result of
●
room smells (furniture, tobacco, etc.) which have been taken into the indoor
unit.
During cooling or dry operation, a thin mist may be seen emitted from the
●
indoor unit. This results from the sudden cooling of room air by the cool air
emitted from the indoor unit, resulting in condensation and misting.
*
During heating operation, the outdoor unit's fan may stop, and steam may be
●
seen rising from the unit. This is due to the automatic defrosting operation.
*
When heating operation is started, fan speed is temporarily very low, to allow
●
internal parts to warm up.
*
During heating operation, if the room temperature rises above the thermo-
●
stat setting, the outdoor unit will stop, and the indoor unit will operate at very
low fan speed. If you wish to warm the room further, set the thermostat to a
higher setting.
*
During heating operation, the unit will temporarily stop operation (between 4
●
and 15 minutes) as the automatic defrosting mode operates. During the au-
tomatic defrosting operation, the OPERATION indicator lamp will fl ash.
The fan may operate at very low speed during dry operation or when the unit
●
is monitoring the room's temperature.
During QUIET operation, the fan will operate at very low speed.
●
In the monitor AUTO operation, the fan will operate at very low speed.
●
In case of multi-type unit, if multiple units are operated in different operation
●
modes as shown below, the units operated afterward will stop and the OP-
ERATION indicator lamp (green) will fl ash.
Heating mode and cooling mode (or dry mode)
●
Heating mode and fan mode
●
: Flashing
Problem
: OFF
See Page
—
—
17
—
—
17
—
17
—
—
—
18
En-15
Advertisement
Table of Contents
