Setting Up Your Device Using Epsonnet Internet Print - Epson EpsonNet 10/100 Base Tx Int. 5e Manual

Setting up your device using EpsonNet Internet
Print
EpsonNet Internet Print supports printing across the Internet
using Internet Printing Protocol. Follow the steps below to set up
the device.
Note:
Before following the steps below, you must make the appropriate IPP
settings in EpsonNet Config. See the EpsonNet Config User's Guide or
"IPP" on page 114 for instructions on setting up IPP. In the steps below,
you will be asked for the IPP URL you set in the IPP setting screen in
EpsonNet Config.
Windows 98/95
1. Make sure that TCP/IP is correctly installed and setup in the
computer and a valid IP address is set for the computer and
device.
2. Make sure that the IPP settings in EpsonNet Config are
correct. See the EpsonNet Config User's Guide or "IPP" on page
114 for instructions on settings for IPP.
3. To start EpsonNet Internet Print, click Start, point to
Programs and then EpsonNet Internet Print, then click Add
EpsonNet Internet Print Port.
Chapter 2 About the Software 142