Panasonic TH-P50ST50A Service Manual page 26

9.2.7. Remove the AC inlet
Caution:
To remove AC inlet wait 1 minute after power was off for
discharge from electrolysis capacitors.
1. Disconnect the connector (P9).
2. Remove the screws (×1
inlet.
9.2.8. Remove the P-Board
Caution:
To remove P.C.B. wait 1 minute after power was off for
discharge from electrolysis capacitors.
1. Unlock the cable clampers and the tapes to free the
cables
2. Disconnect the connectors (P2, P6, P9, P11 and P35).
3. Remove the screws (×6
, ×1
) and remove the AC
) and remove the P-Board.
9.2.9. Remove the A-Board
1. Unlock the cable clampers and the tapes to free the
cables.
2. Disconnect the connectors (A1, A6, A12 and A50).
3. Disconnect the USB cable (JK8605).
4. Disconnect the flexible cables (A20, A31, A32 and A33).
5. Remove the screws (×3
6. Remove the Side shield metal and the Bottom shield
metal.
7. Remove the A-Board.
9.2.10. Remove the Control unit assy
1. Disconnect the connector (C14).
2. Remove the claws (×2
assy.
26
).
) and remove the Control unit