Polaris RZR XP 1000 Owner's Manual page 79

PIN ACTIVATED SECURITY SYSTEM (P.A.S.S.) (IF
EQUIPPED) — INSTRUMENT CLUSTER
For vehicles with the Ride Command display, see page 85 for details.
The optional PIN Activated Security System (P.A.S.S.) is to prevent
unauthorized use. When enabled, the vehicle cannot be operated until a valid
passcode has been entered using the Instrument Cluster.
To enable/disable P.A.S.S. using the Instrument Cluster, follow the procedures
below.
ENABLE P.A.S.S.
After activating P.A.S.S. for the first time you must power down the vehicle and
allow the electronic control module (ECM) to fully shutdown before restarting.
Once a new passcode has been enabled, it cannot be changed unless you first
disable the system. Then you can re-follow the steps outlined in the ENABLE
1. Press and hold the MODE button to enter the "OPTIONS" menu.
2. Use the UP/DOWN toggle buttons to cycle through options until "REQUIRE
PIN TO START" appears. Press the MODE button to select.
3. If required, "ENTER NEW PIN" will appear. Use the UP/DOWN toggle
buttons to cycle to your desired first digit. Press the MODE button to select
the digit.
4. Continue until all four digits of your desired passcode have been selected.
Once finished, "NEW PIN SET" will flash momentarily and then revert back to
the "REQUIRE PIN TO START" screen.
Please record your passcode.
5. To enable your new passcode, use the UP/DOWN toggle buttons to change
the flashing "OFF" at bottom of screen to "ON". If this step is skipped, P.A.
S.S. will not be enabled.
6. Press the MODE button to re-enter the "OPTIONS" menu. The vehicle will
now require passcode entry before next startup.
You can exit the "OPTIONS" menu three different ways.
• Toggle to "EXIT" and press the MODE button.
• Hold the MODE button for a few seconds.
• Do nothing, allowing the system to automatically revert back to the main
screen.
This may take up to three minutes.
P.A.S.S. section to enter a new passcode.
FEATURES AND CONTROLS
NOTICE
77