Electrolux ERN3011FOW User Manual page 15

9.5 Installing the appliance
CAUTION!
Make sure that the mains
cable can move freely.
1. If necessary cut the adhesive sealing
strip and then apply it to the
appliance as shown in figure.
x
2. Drill the unit using a Ø 2.5 mm drill
(10 mm max. penetration).
3. Fix the square fitting to the appliance.
13 mm
1
Ø 2.5 mm
3
4. Install the appliance in the niche.
5. Push the appliance in the direction of
the arrows (1) until the upper gap
cover stops against the kitchen
furniture.
6. Push the appliance in the direction of
the arrows (2) against the cupboard
on the opposite side of the hinge.
x
7. Adjust the appliance in the niche.
Make sure that the distance between
the appliance and the cupboard front-
edge is 44 mm.
The lower hinge cover (in the
accessories bag) makes sure that the
distance between the appliance and
the kitchen furniture is correct.
Make sure that the clearance
between the appliance and the
cupboard is 4 mm.
8. Open the door. Put the lower hinge
cover in position.
2
4mm
44mm
9. Attach the appliance to the niche with
4 screws.
ENGLISH 15
2
1