Pintucking - ELNA eXtend 864air Instruction Manual

Machine Setting
Lower looper
pre-tension
setting slider
Left
Standard setting
needle
of tension dials
-
Stitch length dial
Differential feed
dial
Chaining finger
switch knob
Upper knife
Use the right needle:
Needle
HA-1 SP No. 14 or No. 11
Needle thread Synthetic: No. 80 - 100
Upper looper
Synthetic: No. 80 - 100
thread
Lower looper
Synthetic: No. 80 - 100
thread
Fabric Light weight, knit fabric
z
q
x
STD.
Right Upper Lower
needle looper looper
4 5-7
R
1.0
R
Deactivated
w

Pintucking

NOTE:
• You may need to adjust the thread tension
depending on the type of fabric and thread being
used.
• If the tension balance on the test piece is not
satisfactory, you can adjust the thread tension with
the thread tension dial.
CAUTION
Make sure to turn the power switch off before
changing the needle, deactivating/activating the upper
knife or setting the chaining finger switch knob.
q Left needle thread tension dial
w Right needle thread tension dial
e Upper looper thread tension dial
r Lower looper thread tension dial
t Chaining finger switch knob
y Upper knife release knob
2-4
u Stitch length dial
i Differential feed dial
o Lower looper pre-tension setting slider
* Refer to page 10 for details on how to remove the
needle.
* Refer to page 11 for details on how to adjust the
stitch length.
* Refer to page 11 for details on how to adjust the
difference ratio.
* Refer to page 12 for details on how to deactivate/
activate the upper knife.
* Refer to page 13 for details on how to adjust the
chaining finger switch knob.
t
e
Sewing
z Sew the folded edge while guiding it along the guide
line.
q Right side of fabric
w Folded edge
e Guide line on the needle plate
x Open the fold flat and press the pintucks to one side.
* After you finish sewing, return the upper knife to the
original position (activated).
48
w e
r
q
y
u
i
o