PICTURE CONTROL
Colour Gamut
(Wide/Standard)
Edge Enhancer
(Off/Low/High)
xvYCC
(Auto/off/on)
OPC
(On/Off)
Colour Standard
(SD/HD)
Expert Pattern
(Off/Expert1/Expert2)
Colour Filter
(Off/Red/Green/Blue)
White Balance
(Medium/Warm/Cool)
Colour Management
System
98
S S t t a a n n d d a a r r d d : Mode to reproduce original colour according to the standard of
•
input signal independent of the display characteristics.
W W i i d d e e : : Mode to use and set the rich colour area of the display.
•
Maximize the utilization for colour area that can be expressed.
I
*This feature is not available for all models.
Shows clearer and distinctive yet natural corners of the video.
I
This is the function to express richer colour.
I
This function is enabled in "Picture mode - Cinema, Expert" when xvYCC signal is
I
inputted through HDMI
*This feature is not available for all models.
As the technology to reduce the power consumption while keeping the same
I
brightness, this has the effect of reducing power consumption, improvement in
contrast.
Converts the colour of a different video to HD colour. This function is set for SD
I
video (BT-601) and HD video (BT-709) colour format.
This is the pattern necessary for expert adjustment.
I
This function is enabled in "Picture Mode - Expert" when you watch DTV.
I
This is the function to filter the specific colours of the video.
I
You can use the RGB filter to set colour saturation and hue accurately.
This is the function to adjust the overall colour of the screen to the feeling you want.
I
Method : 2 Points
a. •
Pattern: Inner, Outer
•
Red/Green/Blue Contrast, Red/Green/Blue Brightness:
•
The adjustment range is -50 ~ +50.
b.
Method : 10 point IRE
•
Pattern: Inner / Outer
•
IRE (Institute of Radio Engineers) is the unit to display the size of the video sig-
•
nal and can be set among 10, 20, 30 - 100. You can adjust Red, Green or Blue
according to each setting.
Luminance: This function displays calculated luminance value for 2.2 gamma. You
•
can input luminance value you want at 100 IRE, than the target luminance value for
2.2 gamma is displayed at every 10 steps from 10 IRE to 90 IRE.
Red/Green/Blue: The adjustment range is -50 ~ +50.
•
As the tool used by the experts to make adjustments by using the test patterns, this
I
does not affect other colours but can be used to selectively adjust the 6 colour
areas (Red/Green/Blue/Cyan/Magenta/Yellow).
Colour difference may not be distinctive even when you make the adjustments for
the general video.
Adjusts Red/Green/Blue/Yellow/Cyan/Magenta.
I
Red/Green/Blue/Yellow/Cyan, Magenta Colour : The adjustment range
•
is -30 ~ +30.
Red/Green/Blue/Yellow/Cyan/Magenta Tint : The adjustment range is
•
-30 ~ +30.
This feature is disable in RGB-PC and HDMI (PC) mode.
I