Switching Input Signal - ViewSonic PJD5111 User Manual

Switching input signal

The projector can be connected to multiple devices at the same time. However, it can only
display one full screen at a time.
Be sure the Quick Auto Search function in the SOURCE menu is On (which is the default
of this projector) if you want the projector to automatically search for the signals.
You can also manually cycle through the available
input signals.
1. Press SOURCE on the projector or remote
control. A source selection bar displays.
2. Press
selected and press MODE/ENTER.
Once detected, the selected source information
will display on the screen for seconds. If there
are multiple devices connected to the
projector, repeat steps 1-2 to search for another
signal.
• The brightness level of the projected image will
change accordingly when you switch between
different input signals. Data (graphic) "PC"
presentations using mostly static images are
generally brighter than "Video" using mostly
moving images (movies).
• The input signal type effects the options available
for the Preset Mode. See
mode" on page 28
• The native display resolution of this projector is in a 4:3 aspect ratio. For best display
picture results, you should select and use an input signal which outputs at this resolution.
Any other resolutions will be scaled by the projector depending upon the 'aspect ratio'
setting, which may cause some image distortion or loss of picture clarity. See
the aspect ratio" on page 26
/ until your desired signal is
"Selecting a picture
for details.
for details.
D-Sub / Comp. 1
D-Sub / Comp. 2
Video
S-Video
"Selecting
Operation 23