Advertisement
Assembly Instructions
Seed Box Rework, Right Hand Side
Refer to Figure 6:
1. Locate, mark and drill two 21/32" diameter holes in
the upper left corner of the right hand end panel.
2. Locate, mark and drill two 13/32" and two 9/32"
diameter holes in the upper right hand end panel.
3. If not present, drill two 13/32" diameter holes in the
lower right corner of the right hand end panel.
Small Seeds Box Mounting
Refer to Figure 7:
1. Attach small seeds box to main seed box by inserting
5/16"-18 x 3 1/2" GR5 cap screws (#5) through
backing plates (#2A), main seed box back panel,
spacer tubes (#1), small seeds box front panel, lock
washers (#11) and hex nuts (#7). Draw nuts up snug.
2. Insert 5/16"-18 x 1" GR5 cap screws (#4) through
small seeds box front panel, main seed box rear
panel, backing plates (#2B), lock washers (#11) and
hex nuts (#7).
3. Tighten all installed nuts (#7) to the correct torque.
4. Attach SMV mounting bracket (#13) to small seeds
box with 5/16"-18 x 1/2" GR5 cap screws (#6) and
locknuts (#9). Tighten nuts to the correct torque.
5. Attach removed SMV sign (#12) to mounting
bracket (#13) by inserting 1/4"-20 x 5/8" GR5 round
head screws (#3) through flat washers (#10), SMV
sign (#12), SMV mounting bracket (#13) and flat
washers (#10). Secure SMV sign with locknuts (#8).
Tighten nuts to the correct torque.
4
Manual No. 313-473M
Small Seeds Box Mounting (APS1560 Shown)
Figure 7
*
The two holes marked with an (*) must be drilled only if
your seeder's serial number is 543361 or lower. Seeders
with serial number 543362 and higher are manufactured
with the two holes included.
Main Seed Box Rework - Right Hand Side
Figure 6
Land Pride
26922
26924
3/18/10
Advertisement
