Setting Of Tray Speed - Canon Saddle Finisher-AF2 Service Manual

5.3.2.30 Setting of Tray Speed

Execute this adjustment in the case of abnormal sound when the tray is
moved up/down.
Adjusting method is as follows:
1) Turn ON the power of the finisher.
2) Turn ON the power switch of the host machine to be on standby.
3) Open the front door and put the door switch tool into the door switch [1].
4) Remove the screw [2] to remove the switch cover [1].
[1]
[2]
5) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
[1]
F-5-210
F-5-211
0021-1763
SW382
SW381
6) Press switch SW385 [1] so that this adjustment is ready now.
SW382
SW381
7) Press push switch SW384 [1] to execute setting.
- 0: lifting speed gets slower
- 1: lifting speed gets faster
SW382
SW381
8) Press switch SW385 [1] again to complete this adjustment.
SW382
SW381
[1]
SW383 SW384 SW385
(-) (+) ENTER
F-5-212
SW383 SW384 SW385
(-) (+) ENTER
[1]
F-5-213
SW383 SW384 SW385
(-) (+) ENTER
[1]
F-5-214
SW383 SW384 SW385
(-) (+) ENTER
[1]
F-5-215
Chapter 5
5-45