Table of Contents
Advertisement
TO INSTALL BAGGER SUPPORT ASSEMBLY
(See Figs 8 - 16)
•
Install carriage bolts (1) and locknuts (2) onto upper
clevis brackets (3) and bagger pivot assembly (4) as
shown.
4
2
3
1
•
Using two carriage bolts (5) and two nuts (6), secure the
left hand mid bracket (7) to the left hand front bracket
(8) as shown. Mid brackets should be on the outside
of the front brackets. Repeat on opposite side.
NOTE: Nominal position (9) is when edges of brackets are
aligned as shown.
5
7
•
Connect the strut (10) to the left and right mid brackets
using two carriage bolts (11) on each side. Do not
install nuts in this step.
10
11
•
Install the left bagger pivot (12) using one screw (13)
and one nut (14) as shown. Repeat on opposite side.
12
13
14
ASSEMBLY
2
3
Fig. 8
9
8
6
Fig. 9
11
Fig. 10
Fig. 11
•
Slide weldment (15) through hole in left pivot, then
install the right pivot (16) with one screw (17) and nut
(18) as shown.
15
•
Using one screw (19) and nut (20) install the actuator
bracket (21) as shown.
21
•
Use the spacers (22) to the outside of the actuator (23)
for proper alignment. Secure with 2-3/8" clevis pin (24)
and 1.35" clevis pin (25) clips (26).
26
•
Connect the actuator cables (27) to wire harness (28)
on the backplate.
•
Route the cable assembly along the support brackets
placing the clip (29) on the cable assembly through the
hole in the mid bracket as shown. Secure any excess
cable to the actuator bracket with the zip ties.
27
8
18
16
17
Fig. 12
20
19
Fig. 13
22
23
Fig. 14
29
28
Fig. 15
24
25
Advertisement
Table of Contents
