Audi A6 2011 Repair Manual page 19

9 - Seal
10 - Selector Mechanism
❑ Can only be replaced as a unit
❑ Removing and installing. Refer to
• Perform "Guided Functions" using the Vehicle Diagnostic Tester after removing and installing the selector
mechanism.
11 - Clip
❑ For selector lever cable
12 - Noise Insulation
❑ Not equipped on all vehicles
❑ Allocation. Refer to the Parts Catalog.
13 - Lock Washers
❑ For the noise insulation
❑ Quantity: 4
❑ Replace after removing
Gearshift Mechanism on Transmission
1 - Bolt
❑ 3 Nm +90°
❑ Replace after removing
2 - Drive Position Sensor -
G676- and Drive Position Sen‐
sor 2 - G869-
❑ Removing and instal‐
ling. Refer to
⇒ "1.13 Drive Position
Sensor G676 , Remov‐
ing and Installing", page
34 .
3 - Seal
❑ Replace after removing
4 - Seal
❑ For the selector shaft
❑ Replacing. Refer to
⇒ "1.14 Selector Shaft
Seal, Replacing",
page 36 .
5 - Gearshift Lever
❑ Removing and instal‐
ling. Refer to
⇒ "1.14 Selector Shaft
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Seal, Replacing",
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
page 36 .
6 - Bolt
❑ 10 Nm +90°
❑ Replace after removing
7 - Cover
❑ For the selector shaft
8 - Bolt
❑ 8 Nm +60°
Audi A6 2011 ➤ , Audi A6 Avant 2011 ➤ , Audi A7 Sportback 2011 ➤ , Audi ...
7-Speed Dual Clutch Transmission 0CK - Edition 11.2015
⇒ "1.7 Selector Mechanism, Removing and Installing", page 20 .
15
1. Selector Mechanism