Peavey UA 35T II Specifications

S P E
UA ª 35T II
Utility Amplifier
SPECIFICATIONS
Output Power:
35 watts RMS
Power Bandwidth:
50 Hz-20 kHz, .8% THD Mic
50 Hz-20 kHz, .6% THD AUX
Frequency Response:
50 Hz-20 kHz +0, -2 dB
50 Hz-20 kHz +0, -2 dB Mic/Page
THD (1 kHz):
Aux <.05%
Mic <.2%
Page <.2%
S/N Ratio (22 kHz BW):
Tone controls flat/input control max:
85 dB Aux
58 dB Mic/Page
Tone Controls:
Bass ± 10 dB @ 100 Hz
Treble ±10 dB @ 10 kHz
Inputs:
AUX Input: Dual RCA phono jacks,
summed
Mic/Page Input: Screw terminal input
switchable between mic/page
Input Sensitivity:
AUX Input: 100 mV @ 10K
Mic Input: 1 mV @ 1K
Page Input: 120 mV @ 5K
Outputs:
4 ohms, 8 ohms, 600 ohms, 25 V, 70 V
Output Regulation:
Less than 0.5 dB, no load to full load
Controls:
1 AUX input gain control, 1 mic/page gain
control, 1 bass control, 1 treble control, 1
mic/page select switch
C I F
Indicators:
Power LED
Protection:
Built-in, with AC line fuse
Power Consumption:
120 volts AC, 60 Hz, 100 watts
Dimensions:
4.25" H x 8.25" W x 13.625" D
Weight:
11.5 pounds
Color:
Gray
Other Features:
Mic/Page input has precedence over the
AUX input (defeatable)
FEATURES
¥ 35 watts into 4 ohms
¥ Mic/page inputs (screw
terminals)
¥ Mic/page select switch
¥ Dedicated program input (screw
terminals and RCA jacks)
¥ Bass and treble controls
¥ Mic/page level controls
¥ Direct 4 ohm output (screw
terminal)
¥ Completely isolated 8 ohm, 600
ohm, 25 volt and 70 volt outputs
(screw terminals)
¥ Shelf-top or wall-mount-
able chassis
DESCRIPTION
The UA ª 35T II is a high quality
utility amplifier ideally suited for
varying installation requirements.
It produces 35 watts into 4 and 8
ohm direct connections plus a
I C A T I O
broad range of line amplification.
Level controls are provided for
mic/page and AUX. The AUX input
is accessible via screw terminals
or RCA jacks. Bass and treble
controls are functional on the
total system (mic/page/AUX).
When a signal is present at the
mix/page input, the AUX input is
muted. This feature is internally
defeated when required.
Twenty-five and seventy volt line
output capability is standard
equipment, and the unit is
packaged for shelf or wall mount-
ing convenience. The user-friendly
control layout, coupled with state-
of-the-art circuit design, ensures
reliable long-term operation and
smooth trouble-free installation.
WALL OR SHELF MOUNTING
The UA 35T II can be mounted on
a vertical or horizontal surface
using the brackets formed on the
bottom panel. For mounting on a
wooden or paneled surface, use
No. 6 x 1/2" or larger wood
screws. For mounting onto a
masonry or drywall type surface,
use fasteners that are designed
for this purpose.
ARCHITECTURAL ACOUSTICS®
N S
¨