Ariens Sno-Thro ST926LE Owner's/Operator's Manual page 24

3
1
2
1. Top Jam Nut
2. Bottom Jam Nut
3. Cable Adjuster
DEFLECTOR REMOTE
Deflector must stay in selected position while
throwing snow.
If deflector does not stay in set position:
1. Tighten nut beneath control panel to
increase pressure on deflector control
(Figure 24).
If deflector does not follow full range of travel:
1. Push deflector remote all the way
forward.
2. Loosen adjusting nuts on cable support
bracket underneath the dash panel
(Figure 24).
3. To adjust the deflector lower:
Slide cable down. Tighten bottom nut.
4. To adjust deflector higher:
Slide cable up. Tighten top nut.
5. Check travel and repeat adjustment as
necessary.
No Slack
OS7170
Figure 23
1
1. Adjusting Nuts
2. Cable Support Bracket
DISCHARGE CHUTE
If chute does not stay in position while
throwing snow or if chute does not rotate
freely, adjust the cable under the control
panel so the chute lock fingers engage or
disengage the locking gear.
If chute does not stay in position:
Loosen the cable by loosening the lower
adjustment nut, and then tightening the upper
adjustment nut against the bracket
(Figure 25).
GB - 24
Tighten nut.
OS7175
2
Figure 24