Table of Contents
Advertisement
10 | English
Paint
State
Green
Continuous light
(2 x to 5 x)
Yellow
Continuous light
(1 x)
Flashing light
(5 x)
Red
Continuous light
(1 x)
Flashing light
(5 x)
Constant Electronic control
The Constant Electronic keeps the speed at no load and un-
der load virtually consistent, guaranteeing uniform perform-
ance.
Practical advice
Move the backing pad with disc evenly back and forth with
light pressure to achieve an optimum work result. Pressure
that is too strong reduces the performance capability of the
power tool and causes the grinding tool to wear more
quickly.
Protect the grinding tools against impact.
u
Maintenance and Service
Maintenance and Cleaning
Remove the battery from the power tool before carry-
u
ing out work on the power tool (e.g. maintenance,
changing tool, etc.). The battery should also be re-
moved for transport and storage. There is risk of injury
from unintentionally pressing the on/off switch.
To ensure safe and efficient operation, always keep
u
the power tool and the ventilation slots clean.
After-Sales Service and Application Service
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. You can find explosion drawings and information on
spare parts at: www.bosch-pt.com
The Bosch product use advice team will be happy to help you
with any questions about our products and their accessor-
ies.
In all correspondence and spare parts orders, please always
include the 10‑digit article number given on the nameplate
of the product.
Korea
Tel.: 080-955-0909 (Hotline)
1 609 92A 8HC | (21.12.2022)
Meaning/cause
Battery charged
Battery almost empty (see "Battery charge
indicator", page 8)
Critical temperature has been reached
(motor, electronics, battery)
Battery empty (see "Battery charge indic-
ator", page 8)
Power tool is overheated and will switch off Leave the power tool to cool down and
Power tool is jammed and will switch off
The spindle lock is activated and the power
tool will switch off
You can find further service addresses at:
www.bosch-pt.com/serviceaddresses
Transport
The recommended lithium-ion batteries are subject to legis-
lation on the transport of dangerous goods. The user can
transport the batteries by road without further require-
ments.
When shipping by third parties (e.g.: by air transport or for-
warding agency), special requirements on packaging and la-
belling must be observed. For preparation of the item being
shipped, consulting an expert for hazardous material is re-
quired.
Dispatch battery packs only when the housing is undam-
aged. Tape or mask off open contacts and pack up the bat-
tery in such a manner that it cannot move around in the
packaging. Please also observe the possibility of more de-
tailed national regulations.
Disposal
Battery packs/batteries:
Li-ion:
Please observe the notes in the section on transport (see
"Transport", page 10).
Solution
(see "Battery charge indicator", page 8)
Replace or charge battery soon
Run the power tool at no load and allow it to
cool down
Replace or charge battery
switch it on again
Rectify the blockage and switch the power
tool on again
Deactivate the spindle lock and switch the
power tool on again
Power tools, rechargeable batteries, accessor-
ies and packaging should be sorted for environ-
mental-friendly recycling.
Do not dispose of power tools and batteries/re-
chargeable batteries into household waste!
Bosch Power Tools
Advertisement
Table of Contents
