Related Manuals for Neilsen CT2134
Summary of Contents for Neilsen CT2134
- Page 1 12V DIGITAL BATTERY TESTER CT2134 Ref no.2026# ORIGINAL INSTRUCTION Cannon Tools Limited 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K. Address: SAVE THESE INSTRUCTIONS AND PRECAUTIONS.
-
Page 2: Ec Declaration Of Conformity
In case of alteration of the machine, not agreed upon by us, this declaration will lose its validity. Product description: 12V DIGITAL BATTERY TESTER Model: CT2134 (Ref no. 2026#) Applicable EC Directives: Directive of Electromagnetic Compatibility 2014/30/EU... -
Page 3: Specifications
SPECIFICATIONS: Capability 12 V DC battery tester with charging system output Load Test Capacity 125Amps; 200-1000 cold cranking Amps Digital LED Display Analog, 0-16 VDC (maximum) Test Cycle 5 seconds per test with 1 minute cool down; up to 3 tests in 5 minutes Overall Dimensions 290 x 170 x 90mm Save This Manual... - Page 4 • Maintain tools with care. Keep the Battery Tester clean for better and safer performance. Follow instructions for changing accessories. Inspect product cords periodically, and if damaged, have them repaired by an authorized technician. The handles must be kept clean, dry, and free from oil and grease at all times.
-
Page 5: Testing The Battery
UNPACKING When unpacking, check to make sure that the product is intact and undamaged. If any parts are missing or broken, please call us as soon as possible. OPERATING INSTRUCTIONS Caution! This Battery Tester becomes very hot during use. Touching it will result in serious burns. -
Page 6: Testing The Charging System
4. Press the test button (C), the test procedure is shown on the display. The devise shows the test result after about ten seconds. Attention: Do not test more than three times in a five minute period. Allow one minute for cool down between tests. -
Page 7: Testing The Starter
Testing the Starter This Test identifies excessive starter current draw, which makes starting difficult and shortens battery life. Perform battery load test and proceed only if the battery tests good. Engine should be at normal operating temperature. 1. For this check-up, the engine has to be in working temperature and the battery has to be in perfect condition. -
Page 8: Expanded View
EXPANDED VIEW Part no. Description Part no. Description Top cover Pad post Bottom cover Screw M3 x 25 Display panel Nut M3 Circuit board Plug Outlet sleeve Rubber feet Spare board Screw for rubber feet Heating wire Nut for rubber feet Relay Screw M4 x 8 Clip...