Nedis DOORP10CGT - Security Doorphone Manual
Description (fig. A)
Indoor unit (fig. A1) | |
- Lock/unlock button (electronic lock)
| - Press the button to lock or unlock the electronic lock.
|
- Receiver
| - Pick up the receiver to talking to the visitor outside.
|
- Mounting bracket
| |
- Wiring terminal
| - 4a: Outdoor unit
- 4b: Unlocking the electronic lock
|
Outdoor unit (fig. A2) | |
- Call button
| - Press the button to call the indoor unit.
|
- Speaker
| |
- Microphone
| |
- Rain cover
| |
- Wiring terminal
| |
Wiring diagram (fig. B)
- Indoor unit
- Outdoor unit
- Electronic lock
- External power supply (power adapter)
-
- Red wire
- Black wire
- Negative (-) wire (lock/unlock)
- Positive (+) wire (lock/unlock)
- To extend the cable to 100 m, use 2x 0.65 mm2 wire.
- To extend the cable to 150 m, use 2x 0.8 mm2 wire.
- To extend the cable to 250 m, use 2x 1.0 mm2 wire.
Installation (fig. C)
Indoor unit (fig. C1)
- Drill two holes into the wall. Mount the mounting bracket to the wall using two screws. Pass the wiring through the large hole of the mounting bracket. Tighten the screws to secure the mounting bracket.
- Connect the wires to the indoor unit. Refer to the wiring diagram (fig. B).
- Mount the indoor unit onto the bracket, lining up the four hooks with the grooves in the rear of the indoor unit. Slide the indoor unit down to secure it into place.
- Connect the DC plug of the power adapter to the indoor unit. Connect the AC plug of the power adapter to the wall socket.
Outdoor unit (fig. C2)
- Drill four holes into the wall at a height of 140-170 cm above floor level. Mount the rain cover to the wall using four screws (4x30MM).
- Connect the wires to the outdoor unit. Refer to the wiring diagram (fig. B).
- Insert the outdoor unit into the rain cover. Secure the outdoor unit using two screws (3.5x16MM).
- Seal the screw holes with the silicone caps.
Safety
- To reduce risk of electric shock, this product should only be opened by an authorized technician when service is required.
- Disconnect the product from the mains and other equipment if a problem should occur.
- Read the manual carefully before use. Keep the manual for future reference.
- Only use the device for its intended purposes. Do not use the device for other purposes than described in the manual.
- Do not use the device if any part is damaged or defective. If the device is damaged or defective, replace the device immediately.
- Do not expose the device to high temperatures.
- Do not expose the device to direct sunlight.
- Do not use the device in locations with high humidity, such as bathrooms and swimming pools.
- Do not install the device in areas where interference can be caused by other devices.
- Do not touch the device with wet hands.
Cleaning and maintenance
- Do not clean the inside of the device.
- Do not use cleaning solvents or abrasives.
- Do not attempt to repair the device. If the device does not operate correctly, replace it with a new device.
- Clean the outside of the device using a soft, damp cloth.
Support
If you need further help or have comments or suggestions please visit www.nedis.com/support
Documents / Resources
References
Download manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Nedis DOORP10CGT - Security Doorphone Manual
Need Assistance?
Do you have a question about the DOORP10CGT that isn't answered in the manual? Leave your question here.