Advertisement
TO REPLACE BATTERIES:
Use a Phillips/cross head screwdriver to loosen screw in battery compartment
door (screw remains attached to door). Remove door. Remove old batteries
and insert 3 x 1.5V "C"/LR14 alkaline batteries. Replace door and tighten screw.
CAUTION:
TO AVOID BATTERY LEAKAGE
1) Be sure to insert the batteries correctly and always follow the toy and
battery manufacturers' instructions;
2) Do not mix old and new batteries or alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries;
3) Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to insert them correctly by
matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it away from other electrical
equipment. Reset (switching off and back on again or removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always remove from the product
before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF
BATTERIES.
HELPFUL HINTS
IMPORTANT RESET NOTE:
• If the electronics suddenly "freeze" (stop functioning), the toy will need to be reset. To activate the reset button,
insert the end of a paper clip into the hole labeled "RESET" on the bottom of the toy. If reset does not work, replace
the batteries.
• The batteries that come with the MAGIC SCREEN LEARNING DESK are for in-store demonstration purposes and may
not last as long as replacement batteries.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Consult the dealer or an experienced radio/TV technician for help.
© 2001, 2003 Hasbro, Inc. All Rights Reserved.
® denotes Reg. U.S. Pat. & TM Office.
U.S. Patent No. D460,127
06180
P/N 6258970000
FCC STATEMENT
FOR NEW PRODUCTS AND OFFERS
FOR NEW PRODUCTS AND OFFERS
Questions? Call: 1-800-PLAYSKL
Advertisement
