Advertisement
Parts Definition/ Installation
• First, machine holes on the mounting surface (SK/ SKH only).
• Remove the M4 nuts from bolts and place the product through the mounting surface holes. (SK/ SKH only)
• Fasten the flange nuts(M4) on the opposite side of the mounting
surface until the product is tightened securely (SK/ SKH only).
• models have strong magnets at the base of the product that allows attachment to any metal surface.
Bulb Replacement Instructions/ Mounting Hole Specifications
■ Bulb Replacement Instructions
Assemble
bulb
• Please wait at least 1 minute after turning off the power
before replacing the bulb.
• In order to dissemble the bulb, please push down the bulb( ① )
lightly and screw it counterclockwise.
• In order to put the bulb in to the unit, please place the bulb( ① )
in the socket( ② ) and screw it clockwise while lightly pushing
down the bulb.
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP54.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating
indicated(IP54), it may cause malfunction or damage to the product.
• In case of outdoor applications, install the product in the upright position. Do not install the product horizontal or upside-
down positions where water can potentially penetrate into the product and impact it's operation.
• For further information, please visit our website (www.qlight.com).
SK/ SKH
Lens(PC)
Reflector(PC/ STS)
Light bulb
Housing(PC)
①
②
Disassemble
bulb
SKMP/ SKMPH
Cigarette lighter plug
■ Mounting Hole Specifications
• Machine holes on the mounting surface referring
to the diagram below.
4-Ø5 HOLES
3
Advertisement
