Table of Contents
Advertisement
• When transporting the product, use the forklift or spreader bar in
accordance with the manual.
- Arbitrarily moving the product can cause product damage or injury.
• When moving the product using the forklift, check the weight of
the chiller, size and length of the fork to select the appropriate
equipment.
- It can cause damage or injury.
• When hanging the product on the hoist to move the chiller, make
sure that the load of the product is evenly distributed and leveled
during the move.
- It can cause damage or injury.
• When moving the product using the spreader bar, make sure to
select the spreader bar with material and size to sufficiently
support the strength spreader bar.
- Using inappropriate spreader bar can cause the product to fall
and cause injury due to the strength or size.
• Always ground the product.
- There is risk of fire or electric shock.
• Do not store or use flammable gas or combustibles near the Product.
- There is risk of fire or failure of product.
• Do not reconstruct to change the settings of the protection devices.
- If the pressure switch, thermal switch, or other protection device
is shorted and operated forcibly, or parts other than those
specified by LGE are used, fire or explosion may result.
• Ventilate before operating Product when gas leaked out.
- It may cause explosion, fire, and burn.
• Use a vacuum pump or Inert (nitrogen) gas when doing leakage
test or air purge. Do not compress air or Oxygen and Do not use
Flammable gases. Otherwise, it may cause fire or explosion.
- There is the risk of death, injury, fire or explosion.
Use
• Do not damage or use an unspecified POWER CABLE.
- There is risk of fire, electric shock, explosion, or injury.
• Use a dedicated outlet for this appliance.
- There is risk of fire or electrical shock.
• Be cautious that water could not enter the Product.
- There is risk of fire, electric shock, or product damage.
IMPORTANT SAFETY INSTRUCTIONS
5
Advertisement
Table of Contents
