Table of Contents
Advertisement
Angle Grinder
Article number
Rated input
Output power
No-load speed
Grinding disk dia.
Grinder spindle threads
Starting current limiter
Constant electronics
Speed selection
Weight
Safety class
Machine Elements
1 Ventilation slots
2 Speed selector thumbwheel
3 On/Off switch
4 Auxiliary handle
5 Spindle lock
6 Grinder spindle
7 Clamping lever
8 Protective guard
9 Mounting flange with O-ring
10 Roughing/cutting disc*
11 Clamping nut**
12 Face spanner
13 Hand protector*
14 Rubber sanding plate*
15 Sanding sheet*
16 Round nut*
17 Quick clamping nut**
18 Cup brush*
* Optional accessories
** depends on design
Not all of the accessories illustrated or described are included
as standard delivery.
Intended Use
The machine is intended for cutting, roughing and
brushing metal and stone materials without using water.
For cutting stone, a cutting guide is required.
For machines with electronic control: With approved
sanding tools, the machine can be used for sanding and
polishing.
For damage caused by usage other then intended, the
user is responsible.
All manuals and user guides at all-guides.com
Tool Specifications
EWS 115
702 480 X
750 W
450 W
11 000 RPM
max. 115 mm
M 14
–
–
–
approx. 1.55 kg
/ II
Slots in load carrying walls are subject to the Standard
DIN 1053, Part 1 or country-specific regulations.
These regulations are to be observed under all circum-
stances. Before beginning work, consult the responsible
structural engineer, architects or the construction super-
visor.
Protective Guard
8
7
Note: Coded notches on the protective guard 8 ensure
that only a protective guard that fits the machine type
can be mounted.
EWS 125
702 482 X
1 020 W
600 W
11 000 RPM
max. 125 mm
M 14
•
•
–
approx. 1.60 kg
/ II
Information Structures
Mounting the Protective
Devices
Before any work on the machine itself, pull the
mains plug.
For work with roughing or cutting discs, the protec-
tive guard 8 must be mounted.
Open the clamping lever 7.
Place the protective guard 8 with
coded cams into the respectively
coded grooves on the spindle col-
lar of the machine head and turn
anti-clockwise to the required po-
sition (working position).
To fasten the protection guard 8,
close the clamping lever 7.
The closed side of the protection
guard 8 must always point to the
operator.
EWS 125-E
702 484 X
1 020 W
600 W
2 800 - 11 000 RPM
max. 125 mm
M 14
•
•
•
approx. 1.60 kg
/ II
11
Advertisement
Table of Contents
